Crankshaft Position Sensor “A” Circuit Malfunction (Bank 1) This code essentially means that the vehicle’s electronic control module is not able to detect the crankshaft position sensor. The CKP sensor typically tells the car’s computer how fast the engine is running.

What does crankshaft position sensor a circuit malfunction mean?

Crankshaft Position Sensor “A” Circuit Malfunction (Bank 1) This code essentially means that the vehicle’s electronic control module is not able to detect the crankshaft position sensor. The CKP sensor typically tells the car’s computer how fast the engine is running.

What does error code P0335 mean?

Trouble code P0335 is set whenever the ECM does not sense crankshaft pulses or senses a problem with the pulses in the output with Sensor “A” Bank 1.

How much is crankshaft position sensor cost?

Crankshaft Position Sensor Replacement Cost – RepairPal Estimate. The average cost for crankshaft position sensor replacement is between $173 and $227. Labor costs are estimated between $93 and $117 while parts are priced between $80 and $110.

Where is a crankshaft sensor located?

The location of the crankshaft position sensor can vary from one vehicle to another. Obviously it must be close to the crankshaft, so it is most often located on the front underside of the engine. It can usually be found mounted to the timing cover. Sometimes it may be mounted at the rear or the side of the engine.

Where is crankshaft sensor located?

How much does it cost to replace a crankshaft sensor?

The average crankshaft sensor replacement cost is between $150 and $250. However, it’s not uncommon for those prices to skyrocket if you have a higher-end vehicle. That’s because the labor costs are typically between $90 and $110. From there, the rest of the cost comes down to parts.

How long does it take to change crankshaft sensor?

The labor to replace the sensor is just under 1.5 hours according to my labor guide and the part is approx $50.

What happens if you disconnect crank sensor?

after disconnecting the crankshaft sensor, the car can only started in “limp” mode, can not start as normal. One more thing: I noticed (with crankshaft sensor on), the check engine light gives a code of 1211.