Note: Per Moen, both quick-connect clip versions of this hose are interchangeable.

Are Moen Hydrolock and Duralock interchangeable?

Note: Per Moen, both quick-connect clip versions of this hose are interchangeable.

How do you remove a Moen Hydrolock connector?

Find the two white plastic tabs at the end of the Quick Connect fitting. Squeeze these tabs together with your fingers or pliers. As you squeeze these tabs they will become pushed into the black plastic housing. This will cause the white button on the opposite side of to pop out a little.

What is Duralock quick connect?

QUICK-CONNECT SYSTEM PROVIDES HASSLE-FREE INSTALLATION. Moen’s new Duralock™ Quick-Connect system assures quick, secure and. hassle-free installation for Moen® kitchen and bath faucets. This new solution helps save valuable time for plumbers and DIY installers alike.

How do I replace my Moen quick connect?

Squeeze the white tabs (B) together and push the tabs in. This will cause the white tabs (B) to push back into the quick connect releasing the white button. Installation: Insert the faucet part into the end (A) of the quick connect.

How do you remove a Moen kitchen faucet water line?

Moen’s Faucets: How to Repair Like a Pro

1. Step 1: Shut off the waterline.
2. Step 2: Dry the pipes.
3. Step 3: Extract the faucet’s Handle.
4. Step 4: Take out the plastic part.
5. Step 5: Take out the mechanism.
6. Step 6: Take off the white ring.
7. Step 7: Lift the spout.

How do you remove a quick connect faucet hose?

Push the quick connect up to compress it and keep holding it or the hose while doing this. Put your fingers on the very top of the white quick connect adapter while maintaining the hose upward. Pull the quick connect down and release the hose at the same time.

How do you replace the pullout hose on a Moen kitchen faucet?

Grab ahold of the sprayer and pull the hose out through the faucet toward you.

1. Tighten the spray wand onto the hose.
2. Insert the hose into the opening of the faucet body and feed through.
3. Remove and discard plastic cap from end of pullout hose.
4. Attach the hose back onto the quick connect.

What is Moen Duralock system?

Moen’s Duralock Quick-Connect system offers a secure installation for the company’s kitchen and bath faucets. The time-saving system uses a proprietary, one-step, quick-connect installation, allowing kitchen and bathroom faucets to be installed without the use of tools.

How do I disconnect a Moen quick connect fitting?

Removal: Squeeze the white tabs (B) together and push the tabs in. This will cause the white tabs (B) to push back into the quick connect releasing the white button.

How do I find the model number of my Moen kitchen faucet?

Exact model numbers can be found on your box or on your instruction sheet. If unavailable, you may find the general family series number on the back of the spout (non pullout).

How do you replace a Moen sink hose?

Built-In Quick Connect Types:

1. Tighten the spray wand onto the hose.
2. Insert the hose into the opening of the faucet body and feed through.
3. Remove and discard plastic cap from end of pullout hose.
4. If using a non-snap on hose weight, install the hose weight.
5. Slide the hose into the built-in quick connect:

How do you cap off quick connect sprayer?

Remove The Sprayer Hose Using the pliers, loosen the connector holding the two together. The next step is to attach the kitchen sink sprayer plug. Wipe the exposed male threads on the faucet dry with a towel. Wrap the threads with pipe-joint tape, then twist the ⅜ inch threaded brass flare cap on.